Which safety mat material is good?
safety mat installation 1. Dust removal and cleaning on site: Before formal paving, clean the pavement, especially carefully check whether there is cement mortar leaking from civil engineering and oil pollution caused by oil leakage from paver and road roller. The cement floor should be air-dried, flat, non-convex and flat. 2. Laying of safety mats (1) According to the size of the site, arrange an appropriate number of people to lay it; (2) After entering the site, determine the accurate, material-saving and labor-saving methods according to the requirements of the drawings and the actual site; (3), Find three suitable sides on the field, use one white line horizontally and two vertical lines and extend and cross them at right angles. The distance (maximum distance) between the horizontal and vertical white lines from the edge of the field is 49.549CM. In order to squeeze the floor mat and the surrounding contact, close and seamless; (4), arrange one person to apply special special glue horizontally in the white line from left to right, and arrange another person to lay safety floor mats in turn, with each horizontal and vertical direction. When laying three pieces, that is, the fourth piece, overlap 0.5-1CM forward and to the left (according to the thickness of the floor mat), so that the safety floor mat can be laid tightly when squeezed, and there is no gap in the middle; Safety Mat Specifications HuMei Humei rubber mats, rubber safety mats, safety rubber mats, safety mats, kindergarten rubber mats, kindergarten rubber safety mats, kindergarten safety mats, kindergarten safety rubber mats, children's safety mats, children's rubber Safety mats, children's safety rubber mats, children's safety mats, children's playground safety mats, children's playground rubber safety mats, children's playground safety rubber mats, HuMei Humei children's playground rubber matsHuMei Humei Rubber floor mats are made of rubber particles and adhesives and non-toxic and non-polluting pigments, which are thermoset by molding, and can be produced in different thicknesses, densities and colors according to needs. The commonly used basic specifications are 500×500mm, and the thickness is 1.5cm, 2cm, 2.5cm, and 3cm. The colors are mainly red, yellow, green, blue, gray, and black. safety mat material 1. Nylon: good wear resistance, easy to clean, but easy to deform, easy to generate static electricity, and will partially dissolve in case of fire. 2. Polyester: The abrasion resistance is second only to nylon, heat-resistant and light-resistant. 3. Polypropylene: light weight, good elasticity, high strength; rich in raw materials, good wear resistance and low price. 4. Acrylic fiber: soft, warm and elastic; soft texture, soft color, not easy to lose hair, and anti-slip design on the back; but not strong in water absorption and poor in wear resistance. 5. Pure cotton: pure cotton material, good water absorption; good plasticity of the material, different three-dimensional design changes can be made, and cleaning is very convenient; it can be used with anti-slip pads. 6. Microfiber: The water absorption is 1.5-2 times that of pure cotton, and the fiber fineness is 1/10 of that of pure cotton; the touch is softer than pure cotton, the fiber density is extremely small, it is not easy to adhere to dirt, and it is more convenient to maintain and clean. 7. Coconut fiber: Recycled from natural coconut fiber; environmentally friendly and durable, with natural color and color printing; it can effectively scrape the soles of sand, dirt-resistant and easy to clean.